Production guides · Meme Plugins · 2 November 2026
Reduce vocal plosives by treating the short breath burst rather than removing low frequencies from the entire performance. Preserve the consonant and surrounding vowel, compare a local correction with the original and rerecord when overload has made a clean repair impractical.
1. Confirm the problem is a breath burst
Listen around the word at a useful level. A P or B can drive a low thump into the microphone, but a click, handling bump or bass-heavy voice needs a different diagnosis. Keep a copy and inspect the waveform or spectrogram alongside playback.
iZotope’s plosive-repair guide explains the low-frequency burst and warns that broad low cuts can also remove useful voice tone. Some plosives include distortion, so reducing bass alone may leave a damaged sound.
2. Start with the smallest useful region
Locate the burst’s beginning and end by listening, including the word’s full context. Compare a small local clip-gain reduction. Add smooth transitions to prevent the edit itself from clicking.
If gain reduction weakens the whole consonant too much, compare a temporary high-pass or low-frequency reduction limited to the burst. Choose the cutoff and amount from that recording; no universal frequency separates every plosive from every voice.
Example: preserve the vowel in an original phrase
Imagine the original phrase “Bring back the blue light,” with a distracting burst on the first B. This is a hypothetical edit exercise, not a supplied or repaired recording.
- Duplicate the phrase and mark the burst separately from the following vowel. Keep the original available for comparison.
- Try a modest gain reduction on the marked burst only, using short smooth boundaries. Play the whole word, then the full phrase.
- Restore the copy and compare a local low-frequency reduction over the same event. Extend the treatment only if the audible burst extends farther.
- Choose the less distracting correction while checking that the B remains intelligible and the vowel’s body is unchanged outside the region.
If both versions sound lisped, hollow or distorted, reduce the treatment or use another take. These steps do not promise recovery of information lost to overload.
3. Check the next recording position
Compare a pop filter, a small change away from the direct breath stream or a suitable distance change. Recheck tone, room sound and gain after moving. Use short placement test takes before recording the full performance again.
4. Verify the repair in context
Listen through the preceding and following words at a comparable level. Check whether compression later brings the remaining thump forward or exaggerates an edit. Reopen the render and confirm that the change stays local.
For a broader filter decision, read the high-pass guide. Do not keep a permanent aggressive filter solely because one word needed attention.