Production guides · Meme Plugins · 1 November 2026
Use mid-side EQ when you need to change the tone of the sum or difference information in a stereo signal. Mid is derived from left plus right; side is derived from left minus right. These are signal combinations, not separate collections of centre instruments and hard-panned instruments.
iZotope’s sum/difference explanation describes the encoding and decoding, including gain normalization. A panned source can contribute to both mid and side, so mid-only EQ does not isolate the lead vocal from everything else.
Example: decode one pair of sample values
This arithmetic example illustrates the matrix only. It is not a measured mix or an audible demonstration. Choose the normalized convention M=(L+R)/2 and S=(L-R)/2, so decoding uses L=M+S and R=M-S.
- For
L=0.6andR=0.2, the matrix givesM=0.4andS=0.2. - Decoding restores
L=0.4+0.2=0.6andR=0.4-0.2=0.2. - For a hard-left value
L=0.6, R=0, bothMandSequal0.3. Hard-left information is therefore present in both components.
Implementations can place normalization gain at different stages. Do not compare soloed component meter values across plugins without checking that convention.
1. Choose the path and a specific problem
Prefer a source-level fix when you still have the multitrack session. On a stereo pad or mixed recording, identify a particular tonal issue rather than adding mid-side processing by habit.
Briefly audition the components if the processor permits it, then return to the decoded stereo output. A strange soloed side signal is not evidence that the stereo mix is broken.
2. Make one controlled tonal comparison
FabFilter’s stereo options document per-band left, right, mid and side placement. Confirm the intended placement in your own device; changing the display or audition mode alone may not change where an EQ band operates.
Imagine a stereo pad whose difference information has an overly bright edge while the lead vocal is already clear. This is a hypothetical session exercise:
- Keep the pad’s level, width setting and other processing fixed.
- Compare a small side-only high-shelf reduction with bypass. Listen to the decoded pad in the song, not just the soloed side.
- Check whether the tone improves or the pad becomes too narrow or dull in that range.
- Restore stereo placement and compare an ordinary two-channel shelf too. Keep the simpler change when it gives the useful result.
The side-only change does not identify a particular instrument within a complete mix. Check every source sharing that signal combination.
3. Verify mono and later processing
For an ideal matrix with unchanged mid and no later processing that couples the components, a side-only change cancels from the mono sum. That is a limitation of what the change can fix: it cannot make a missing mono vocal clearer.
Use the mono workflow, compare at matched level and check the reopened export. Later saturation, linked dynamics or another stage can change the overall interaction, so inspect the full chain.
Should all low-frequency side information be removed?
No. Decide from the source and destination. A blanket rule can remove intended ambience or alter the arrangement’s character.