How to use the calculator
Enter your project tempo between 20 and 400 BPM. The table updates with straight, dotted and triplet note lengths from a whole note to a sixty-fourth note. Read the row matching your intended rhythm, then enter that millisecond value into a delay that is not already synchronised to the project.
For example, at 120 BPM a quarter note lasts 500 ms, a dotted eighth lasts 375 ms and an eighth-note triplet lasts about 166.67 ms. A dotted value is one and a half times the straight duration. A triplet value is two thirds of the corresponding straight duration.
Reverb pre-delay and decay
Pre-delay is the gap before the reverb begins. The suggested range uses short note divisions to give an attack some room before the wash arrives. Decay suggestions correspond to one, two and four beats. They are arrangement-based starting points, not measured acoustic RT60 values or promises about a particular plugin.
A long decay can blur the next lyric even when it is mathematically related to the tempo. Listen to the end of a phrase, adjust the tail and return level, then compare in the full mix. The Audio Pope will accept a shorter room if the congregation can finally hear the words.
Common mistakes
Check whether your delay already uses beat sync: entering milliseconds into a synced control can do something unexpected. Do not confuse milliseconds with seconds. A three-beat bar and a four-beat bar share the same quarter-note duration at the same quarter-note BPM. Swing and deliberately loose repeats may require timing that differs from this straight-grid calculation.
Frequently asked questions
What is the BPM to ms formula?
A quarter note is 60,000 divided by BPM in milliseconds. A whole note is four times that duration.
What is a dotted delay?
A dotted note lasts 1.5 times its straight value. At 120 BPM a dotted eighth is 375 ms.
Should reverb decay always match the tempo?
No. Tempo gives a useful ruler, but the source, arrangement and desired space should decide the actual tail.
Does this process audio?
No. It calculates timing only. Audio tools elsewhere in this package process audio in the browser and never upload it.