Hear practical ways to make room between a kick drum and a bass part. Load two separate local stems, balance their levels, try a broad low-end cut or duck the bass from the kick, then switch between the processed and unprocessed pair.
The Kick & Bass Mixer runs in your browser. This component does not upload audio, use your microphone or require an account. Your original files stay unchanged. You supply the separate kick and bass stems; this tool does not split a full song.
Try the Kick & Bass Mixer
Open the mixer in a full tab. Use the full-tab version if your browser blocks a download in the embedded tool.
How to compare kick and bass
- Keep a common song start. Export your kick and bass from the same DAW start with leading silence intact. The start-delay controls add silence; they never trim the front.
- Balance the parts first. Bypass ducking and EQ, set the relative levels and render. Then enable a small amount of ducking and compare again.
- Follow the envelope. Start with the example settings of 6 dB maximum reduction, 5 ms attack and 180 ms release. The mint curve shows the actual reduction applied to both bass channels. These settings are a starting point, not a rule.
- Take the result back to the song. Download the processed bass and the combined kick/bass preview as separate 48 kHz, 24-bit WAV files. Put them at timeline zero in your DAW. The files include the same output trim and shared safety pad shown by the tool.
Worked example: four bars of low end
Choose Load synthetic example for an original four-bar pattern at 120 BPM. A mono kick falls every half second. A stereo bass plays a fundamental and two harmonics. Both start at zero. With the shelves off, compare 6 dB maximum reduction, 5 ms attack and 180 ms release against the unprocessed pair. Then render with 400 ms release. Watch how the bass reduction lasts further into the next note and choose the groove that fits.
A/B matching turns down the louder version using full-timeline RMS. It is not a LUFS or perceptual loudness match. A/B, monitor level and the loop selection affect audition only. Each WAV retains the full common timeline, including the longest stem and a one-second filter decay allowance when a nonzero shelf is active.
What this tool can and cannot decide
Two sounds sharing low frequencies is not automatically a fault. Arrangement, note length, sound choice and the rest of the mix matter. There is no universal correct crossover or mix-quality score here. The optional shelves are broad cuts around a fixed 100 Hz midpoint; ducking reduces the whole bass signal from a linked, pre-fader kick detector.
Use mono or stereo files up to 120 seconds and 40 MiB each. The browser decodes and resamples to 48 kHz. WAV is the safest input; other codec support varies, and lossy formats may add timing padding. The safety pad controls sample peaks, not intersample peaks. The tool does not perform mastering, automatic phase alignment, tempo stretching or stem separation. Phone memory and file-picker behaviour need device-specific checks.
This local-processing statement applies to this component. The surrounding WordPress page may use its own services; see the site’s privacy information.
Keep learning
How to give kick and bass separate roles · How to use sidechain compression.